Adaptec 5ANA-940 - Manual (Page 49)

5-1
5
▼ ▼ ▼ ▼
Installing ATM Version 2.0x
Drivers for Windows NT
This chapter explains how to install, use, reconfigure, and remove
Adaptec ATM software (versions 2.0x) for Windows NT
workstations and servers (with versions 4.0 or 3.51).
Installation for Windows NT (version 4.0)
The procedures below describe installation of ATM, Classical IP
(CIP), and Lan Emulation (LANE) client device drivers when setting
up a Windows NT ATM server using version 4.0.
Note: For information on how to install these drivers to
Windows NT 3.51, refer to the Installation for Windows NT
(version 3.51) section later in this chapter.
To ensure correct device configuration, install these drivers in the
following order:
■ Classical IP (CIP) client drivers
■ LANE drivers
■ CIP ARP server (optional drivers, purchased separately)