Adaptec 5ANA-940 - Manual (Page 58)

5-10
ANA-5910/5930/5940 User’s Guide
Set the parameters in the dialog box as follows, and select OK:
8 Remove the RFC 1577 CIP ARP Server diskette from the
diskette drive.
9 Select Close to exit the Network Settings dialog box.
10 Select Yes to save and initialize changes.
Determining the CIP ARP Server Address
Note: Enter commands such as aatmcnfg should be entered
from the MS-DOS command prompt, which you can access
by selecting the MS-DOS Command Prompt icon in
Program Manager’s Main group window.
To obtain the 20-byte, ATM ARP server address
Note: The ATM driver should be started and registered to
the switch.
1 On the ARP server, enter the following command from the
directory (
\etc\opt\adptaatm\bin ) where the ATM CIP software
was installed:
aatmcnfg -p
The ATM address for the ARP server appears, for example,
39.11.22.11.22.11.22.00.00.11.22.11.22.00.00.d1.00.04.45.00
Parameter Setting
IP Address Enter the logical IP subnet where this
ATM ARP server resides; 15
characters maximum; 4 bytes, dotted
decimal format; for example,
192.9.200.0
Subnet Mask Enter the IP subnetwork mask for the
ATM adapter; 15 characters
maximum; 4 bytes, dotted decimal
format; for example, 255.255.255.0
Autostart ARP Server Select the check box to automatically
start the ARP server driver at boot-up.