Nova-Tech Digi–Sense 12-Channel Benchtop Scanning Thermometer - Manual (Page 37)

36
Front panel displays and controls continued
How to adjust the print rate
NUM
PRINT
How to adjust the print rate
The print rate is the time the instrument waits between printing
temperature scans on the attached printer.
A printer must be attached and turned on. The instrument only sends the
data, there is no alarm or storage of print information if the printer is
disconnected or turned off.
The PRINT button must be pushed and PRINT displayed.
The default setting is 00:20 (20 seconds).
It takes 4 seconds to do one 12 channel scan so a print rate of 00:04 is the
maximum obtainable.
Note: If the print rate is set more often than the scan rate (lower time
setting) the instrument will scan and print at the print rate.
To adjust the print rate:
1. Push MENU until the PRINT RATE displays or push MENU at
least once, then push PRINT.
RATE 1a is displayed and the current setting 1b flashes.
PRINT 1c is displayed.
NUM 1d appears and flashes indicating number keys are active.
2. Push number keys 2 to enter the print rate. (For example, 36:12 is
entered by pushing 3 - 6 - 1 - 2.)
3a. Push EXIT to save the setting and return to scanning, or
3b. Push MENU to switch to the next setup topic (adjust the log rate).
+ -
A L A R M
E X I T
MENU
1
S T O R E
2
L O G
3
R E C A L L
4
P R I N T
5
M A X
6
M I N
7
A V G
8
H O L D
9
S C A N
NUM PRINT
1b 1, 3b
3a
1a
1d 2 1c
0
CLEAR
BA 32-36 10/12/01, 11:04 AM 36