Configuring protocol groups, Mapping protocols to vlans, Figure 3-82. protocol vlan configuration – Alcatel Carrier Internetworking Solutions OmniStack 6300-24 User Manual

Page 177

Advertising
background image

VLAN Configuration

3-137

3

Configuring Protocol Groups

Create a protocol group for one or more protocols.

Command Attributes
Protocol Group ID – Group identifier of this protocol group.

(Range: 1-2147483647)

Frame Type – Frame type used by this protocol. (Options: Ethernet, RFC_1042,

LLC_other)

Protocol Type – The only option for the LLC_other frame type is IPX_raw. The

options for all other frames types include: IP, ARP, RARP.

Web – Click VLAN, Protocol VLAN, Configuration. Enter a protocol group ID, frame
type and protocol type, then click Apply.

Figure 3-82. Protocol VLAN Configuration

CLI – The following creates protocol group 1, and then specifies Ethernet frames
with IP and ARP protocol types.

Mapping Protocols to VLANs

Map a protocol group to a VLAN for each interface that will participate in the group.

Command Usage
• When creating a protocol-based VLAN, only assign interfaces using this

configuration screen. If you assign interfaces using any of the other VLAN
commands such as VLAN Static Table (page 3-130) or VLAN Static Membership
(page 3-132), these interfaces will admit traffic of any protocol type into the
associated VLAN.

Console(config)#protocol-vlan protocol-group 1

add frame-type ethernet protocol-type ip

4-188

Console(config)#protocol-vlan protocol-group 1

add frame-type ethernet protocol-type arp

Console(config)#

Advertising