Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 263)

System Management Commands
4-51
4
Example
Related Commands
sntp server (4-51)
sntp poll (4-52)
show sntp (4-52)
sntp server
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command specifies time servers from which the switch will poll for time
updates when set to SNTP client mode. The client will poll the time servers in
the order specified until a response is received. It issues time synchronization
requests based on the interval set via the sntp poll command.
Example
Related Commands
sntp client (4-50)
sntp poll (4-52)
show sntp (4-52)
Console(config)#sntp server 10.1.0.19
Console(config)#sntp poll 60
Console(config)#sntp client
Console(config)#end
Console#show sntp
Current time: Dec 23 02:52:44 2002
Poll interval: 60
Current mode: unicast
Console#
Console(config)#sntp server 10.1.0.19
Console#