Link aggregation commands, Table 4-47, Linnk aggregation commands – Alcatel Carrier Internetworking Solutions OmniStack 6300-24 User Manual

Page 359

Advertising

Link Aggregation Commands

4-147

Link Aggregation Commands

Ports can be statically grouped into an aggregate link (i.e., trunk) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a trunk link
between this switch and another network device. For static trunks, the switches have
to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches
have to comply with LACP. This switch supports up to six trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate bandwidth of
4 Gbps when operating at full duplex.

Guidelines for Creating Trunks

General Guidelines –
• Finish configuring port trunks before you connect the corresponding network

cables between switches to avoid creating a loop.

• A trunk can have up to eight ports.
• The ports at both ends of a connection must be configured as trunk ports.
• All ports in a trunk must be configured in an identical manner, including

communication mode (i.e., speed, duplex mode and flow control), VLAN
assignments, and CoS settings.

• All the ports in a trunk have to be treated as a whole when moved from/to,

added or deleted from a VLAN via the specified port-channel.

• STP, VLAN, and IGMP settings can only be made for the entire trunk via the

specified port-channel.

Table 4-47. Linnk Aggregation Commands

Command

Function

Mode

Page

Manual Configuration Commands
interface port-channel

Configures a trunk and enters interface