Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 239)

System Management Commands
4-27
4
Command Mode
Global Configuration
Command Usage
• You cannot set a null password. You will have to enter a password to change
the command mode from Normal Exec to Privileged Exec with the enable
command (page 4-19).
• The encrypted password is required for compatibility with legacy password
settings (i.e., plain text or encrypted) when reading the configuration file
during system bootup or when downloading the configuration file from a TFTP
server. There is no need for you to manually configure encrypted passwords.
Example
Related Commands
enable (4-19)
IP Filter Commands
management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore the
default setting.
Syntax
[no] management {all-client | http-client | snmp-client | telnet-client}
start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, Web and Telnet groups.
• http-client - Adds IP address(es) to the Web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Console(config)#enable password level 15 0 admin
Console(config)#
Table 4-11. IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed management access GC 4-27
show management Displays the switch to be monitored or configured from a
browser
PE 4-28