Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 69)

Configuring Event Logging
3-29
3
to complete the configuration. Use the show logging sendmail command to display
the current SMTP configuration.
Resetting the System
Web – Click System, Reset. Click the Reset button to restart the switch.
Figure 3-15. Resetting the System
CLI – Use the reload command to restart the switch.
Note: When restarting the system, it will always run the Power-On Self-Test.
Setting the System Clock
Simple Network Time Protocol (SNTP) allows the switch to set its internal clock
based on periodic updates from a time server (SNTP or NTP). Maintaining an
accurate time on the switch enables the system log to record meaningful dates and
times for event entries. You can also manually set the clock using the CLI. (See
“calendar set” on page 4-53.) If the clock is not set, the switch will only record the
time from the factory default set at the last bootup.
Console(config)#logging sendmail host 192.168.1.4 4-47
Console(config)#logging sendmail level 3 4-47
Console(config)#logging sendmail source-email
[email protected] 4-48
Console(config)#logging sendmail destination-email
[email protected] 4-48
Console(config)#logging sendmail 4-49
Console(config)#exit
Console#show logging sendmail
4-49
SMTP servers
-----------------------------------------------
Active SMTP server: 0.0.0.0
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. [email protected]
SMTP source email address: [email protected]
SMTP status: Enabled
Console#
Console#reload 4-22
System will be restarted, continue <y/n>?