Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 257)

System Management Commands
4-45
4
Command Mode
Privileged Exec
Example
Related Commands
show logging (4-45)
show logging
This command displays the logging configuration, along with any system and event
messages stored in memory.
Syntax
show logging {flash | ram | sendmail | trap}
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on
power reset).
• sendmail - Displays settings for the SMTP event handler (page 4-49).
• trap - Displays settings for the trap function.
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows that system logging is enabled, the message level for
flash memory is “errors” (i.e., default level 3 - 0), the message level for RAM is
“debugging” (i.e., default level 7 - 0), and lists one sample error
Console#clear logging
Console#
Console#show logging flash
Syslog logging: Enable
History logging in FLASH: level errors
[0] 0:0:5 1/1/1 "PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[0] 0:0:5 1/1/1 PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#