Ransburg Vector Solo AA90 79698 - Manual (Page 31)

Vector Solo AA90 Applicators - Maintenance
Ransburg
27 AH-08-04.2
BARREL REMOVAL
1. Remove air cap and fluid nozzle.
Figure 23: Rear Cover Removal
Figure 24: Fluid Adjust Bushing Removal
4. Remove the trigger and fluid line.
Figure 25: Fluid Line/Trigger Removal
2. Remove two (2) screws with a 3mm Allen wrench
that hold the rear cover. Remove rear cover and
disconnect the connector.
3. Remove the rear fluid adjustment bushing and
air valve and fluid needle return springs.
4. By hand push the seal into the tip holder as
shown. The seal will be held in place in the holder.
Then place the tip holder on the insertion tool.
Hold the tip upright, align the pin in the cap to the
slot in the tip holder and push together. The tip
should snap in place in the air cap.
Figure 22: Seal Install/Carbide
Tip Holder Install
C C W
C C W