Ransburg Vector Solo AA90 79698 - Manual (Page 44)

Vector Solo AA90 Applicators - Maintenance
Ransburg
40 AH-08-04.2
4. Slide the compression ring and the sleeve into
the fitting body and tighten.
Air Hose -Applicator End
1. Cut the end of the air hose so that end is square.
2. Install the 79930 fitting (std) or 79868 (qd)
into the hose end. Lightly lubricate the barb end
of the fitting with LSCH-0009 di-electric lubricant.
Push the fitting into the air hose up to the threads
on the stem.
3. With the 79330 fitting, hold the hose in one hand
and press a 6mm or 1/4" t-handle allen wrench
into the hex in the part while turning clockwise.
Tighten till cap is approximately .8 mm (1/32")
from the swivel nut.
Resistance Test
1. If the hose is changed, the resistance must
be checked. Using a Meg Ohm meter at 1000V
measure the resistance from the lug of the ground
wire to the body of the QD (79868) or the swivel
nut (79930). The reading must be less than .5
Mega Ohms resistance end to end.
Figure 75: Sleeve Tightening
Figure 76: Fitting Insertion
Figure 77: Tightening 79930 Fitting
4. With the 79868 DQ fitting, hold the hose in one
hand and press against a firm surface while turning
the body wrench flat clockwise. Tighten till cap is
approximately .8 mm (1/32") from the QD base.
Figure 78: Tightening 79868 QD Fitting
Figure 79: Air Hose Resistance Test
0.8mm (1/32")
0.8mm (1/32")