Ransburg Vector Solo AA90 79698 - Manual (Page 33)

Vector Solo AA90 Applicators - Maintenance
Ransburg
29 AH-08-04.2
Reinstalling Barrel
1. Replace the hook. Install the barrel against
the handle and hand tighten two (2) long 5mm
screws, in an alternating sequence with the 4mm
Allen wrench. Tighten the hook screw with the
same 4mm wrench.
Figure 33: First Jam Nut Replacement
Figure 32: Installing Barrel to Handle
1 - 79793-00 Removal Tool
2 - 1st Jam Nut
3 - 79854-00 Special Wrench
4 - 2nd Jam Nut (Raised Center)
2. Install the first jam nut. Tighten to stop by hand
while holding the needle shaft.
† Failure to use the LSCH0009-00 may
shorten product life.
Figure 31: Cascade Replacement
Replace Cascade
1. Dispense about 1/4 tube of LSCH0009-00
inside the barrel and on the sides of the cascade.
2. Slide the cascade back into the barrel.
Remove Cascade
1. Pull the cascade out of the barrel.
Figure 30: Cascade Removal
2. Wipe off excess dielectric lubricant.
3. Remove excess lubricant from inside barrel
with a clean cloth or rag.
C A U T I O N !