Ransburg RMA Indirect A11600 - Manual (Page 12)

SPECIFICATIONS *
Mechanical
Electrical
Power Supply
Type: MicroPak
Charging Method: Indirect
Output Voltage: 30-70 kV Variable
Output Current: 1000 µA
Turbine Speed
Control: Eurocard Atomizer Module
Internal/External
Shaping Air
Control: Eurocard AirTronic Module
Part Sprayability: Determine sprayability of
part to be coated using Test Equipment (76652)
(See current Paint, High Voltage & SCI Test
Equipment Service Manual).
Length: (See Figure 1)
Diameter: (See Figure 1)
Approximate Weight:
Atomizer Only: 18.4 lbs. (8.43 Kg)
Total Payload: 21.08 lbs. (9.6 Kg)
Turbine Type: Air Bearing Impulse
Drive
Turbine Air Supply: Variable
Maximum/Minimum
Turbine Speed: Continuous
All Bell Cups: 70K rpm max./
20K rpm min.
Bearing Air Supply: 90 psig (±10 psi)
(Nominal): (621 kPa ±69 kPa)
2.9 SCFM (82 slpm)
Mechanical (Cont.)
Maximum Angular
Velocityfor Turbine
(Robot Motion) :250°/sec.
Shaping Air #1
(SAI) Supply: Variable
(See "Pressure Flow Data Charts" in this section.)
Shaping Air #2
(SAO) Supply: Variable
(See "Pressure Flow Data Carts" in this section.)
Brake Air Supply: 60-100 psig
(Nominal): (414-689 kPa)
Maximum Fluid Pressure Supply:
Paint: 200 psi (1379 kPa)
Solvent: 150 psi (1035 kPa)
Fluid Flow Rate: 25-700 cc/min.
Bell Cup Cleaning Time
(Internal/External): 2-7 sec. (Approx.)
Color Change Time: Dependent on system
configuration, fluid pressures, fluid viscosity,
fluid line lengths, etc.
Speed Readout: Magnetic pick-up, unidi-rec-
tional fiber optic transmission
Bell Cup Replacement
Time: Less than 2 minutes
Minimum Control Equipment
Requirements:(Versions listed or higher)
MicroPak LECU5004-17 (V3.83)
Atomizer Module 76011-01 (V3.42)
I/O Module A11435 (V1.4)
(0-10V) (4-20 mA)
* Specifications and ratings based on
testing at sea level standard conditions.
RMA-303 Indirect Charge - Introduction
Ransburg
8 LN-9252-06.4