Ransburg, Disassembly procedures – Ransburg RMA Indirect A11600 User Manual
Page 53
DISASSEMBLY PROCEDURES
>
The outer protective cover may have to
be replaced more frequently than weekly.
Daily inspection of the amount of paint
buildup on the cover will determine the
frequency of replacement.
NOTE
Atomizer Removal/Replacement
NOTE
>
For re-assembly instructions, use the
reverse of the following disassembly pro-
cedures.
NOTE
>
To fascilitate atomizer removal from
hose manifold, a robot program should be
made that purges all paints and solvents
from the RMA-303. Ideally it would then
position the bell assembly in a bell remov-
al position where the bell cup is pointed
downward at a 30° angle. Any residual
solvents would be contained in the "J
bend" of the robot wrist.
NOTE
>
All o-rings described in the "Mainte-
nance" section of this manual should be
lubricated with a food grade petroleum
jelly or with A11545 lubricant.
W A R N I N G
>
Carefully remove the quick disconnect
ring to insure any residual line pressure
has been relieved to atmosphere.
W A R N I N G
>
Prior to removing applicator fom the
robot, the following tasks must be com-
pleted:
• Robot put into E-stop mode, locked,
and tagged-out.
• All fluid passages are cleaned, purged
out, and depressurized.
• Air turned off.
!
Figure 13: Atomizer Removal from Robot
!
CCW
TO
REMOVE
RMA-303 Indirect Charge - Maintenance
Ransburg
49
LN-9252-06.4