Ransburg RMA Indirect A11600 - Manual (Page 60)

>
To remove, turn the tip CLOCKWISE.
The thread on the tip is left handed.
Replacement
Apply a light coating of o-ring lubricant to all the
o-rings and the threads of the turbine and turbine
retaining ring prior to assembly. Push the turbine
down into the cavity in the atomizer body. Align the
mark on the turbine with the mark on the atomizer
body. Install the turbine retaining ring and o-ring
by hand. Use the spanner wrench to tighten an
additional 1/8-1/4 turn. (Lightly lubricate o-ring
with petroleum jelly.) Check centering of fluid tube.
If fluid tube is centered, the turbine is fully seated.
If not, check tightness with spanner wrench. If
tube is not centered, again remove turbine and
check for causes, such as an o-ring fell off, fiber
optic not fully installed, foreign material on seating
surface, etc. Reinstall and recheck tube centering.
Fluid Tip Removal/Replacement
Removal
To remove the fluid tips, use the tip/tube removal
tool (A11229-00). Insert the tool over the tip and
engage the four (4) prongs of the tool into the
four (4) slots in the tips (see Figures 25 and 26).
Figure 27: Turbine Removal
Figure 28: Fluid Tip Removal
The fluid tip may be removed either with the tur-
bine in place, or the turbine off the unit. Figure
30 shows removing/reinstalling the tip with the
turbine in place.
This allows removal and replacement of the fluid
tip while the applicator is on line.
Check for leaks.
Figure 29: Fluid Tip Replacement
NOTE
Figure 30: Reinstall Fluid Tip
A11229-00
TOOL
FLUID
TIP
ENGAGE
PRONGS
INTO SLOTS
RMA-303 Indirect Charge - Maintenance
Ransburg
56 LN-9252-06.4