Ransburg RMA Indirect A11600 - Manual (Page 85)

Apply A11545 lubricant onto all o-rings before installation.
Install valve assemblies as shown. Apply A11545 lubricant onto o-rings. Torque to 15-20 lbs•in (1.7-2.3 Nm) after
valve is down.
Install valve seat assemblies as shown. Torque to 15-20 lbs•in (1.7-2.3 Nm).
PARTS LIST BULLET DEFINITION TABLE (Figure 65)
1 A11683-00 Solvent/Air Chop Manifold 1
2 77762-01 Collet, 6mm 2
3 79001-32 O-Ring, Solvent Proof 2
4 79001-30 O-Ring, Solvent Proof 2
5 77516-04 Collet, 4mm 2
6 79001-34 O-Ring, Solvent Proof 2
7 77762-04 Collet, 8mm 2
8 78266-00 Fitting, 10mm, AN 1
9 78272-00 Ferrule, Back, 10mm 1
10 78274-00 Nut, Modified, 10mm OD 1
11 78271-00 Ferrule, Front, 10mm 1
12 78265-00 Fitting, 6mm, AN 1
13 78269-00 Ferrule, Front, 6mm 1
14 78270-00 Ferrule, Back, 6mm 1
15 78273-00 Nut, 6mm OD 1
16 79001-31 O-Ring, Solvent Proof 1
17 77762-02 Collet, 10mm 1
18 78949-00 Valve Assembly 2
19 77367-00 Valve Seat Assembly 2
Item #
A11692 VALVE MANIFOLD ASSEMBLY - PARTS LIST
(Figure 61)
Part # Description Qty
Figure 61: A11692 Valve Manifold Assembly
18 19 8 12 13 11 14 9 10
15
1
4 4 5 5 7 6
7
2
17
2
6 16 3
3
19
18
3
3
3
3
2
1
3
2
1
RMA-303 Indirect Charge - Parts Identification
Ransburg
81 LN-9252-06.4