Ransburg RMA Indirect A11600 - Manual (Page 58)

Splash Plate Removal
After removing the bell cup from the applicator, put
it on a plastic or wood surface to prevent damage
to the edge of the cup. Using the splash plate
removal tool (A11388-00), insert the small end of
the tool into the end of the splash plate assembly.
Press the splash plate out. It may be necessary
to tap lightly with a hammer.
> Failure to tighten the bell cup in place
may cause vibration of the applicator
and/or premature turbine failure.
C A U T I O N
!
Figure 23: Splash Plate Removal
Splash Plate Insertion
Turn the splash plate removal tool over and use
the large diameter end to press the splash plate
back in place by hand. It may be necessary on
occassions to use an arbor press to install the
splash plate. Press splash plate to a hard stop
(see Figure 24).
Care must be taken not to over-press the splash
plate assembly into the bell cup. Damage may
occur.
Figure 24: Splash Plate Insertion
Figure 22: Effective Length Torque Wrench
Example: A desired true torque is desired
using a 9-inch effective length torque wrench.
Wrench offset is 3-inches.
L = 9-inches
TT = 50 lbs•in
E = 3-inches
DR is dial reading.
DR = 50 (9) DR = 37.5 lbs•in
(9+3)
SPLASH PLATE
ASSEMBLY
REMOVAL TOOL
BELL CUP
PRESS
THIS
DIRECTION
FLAT WOOD
OR PLASTIC
SURFACE
CUP
SECTION
VIEW
BELL
CUP
INNER
SURFACE
SPLASH
PLATE
BOTTOM
PRESS
THIS
DIRECTION
FLAT WOOD
OR PLASTIC
SURFACE
RMA-303 Indirect Charge - Maintenance
Ransburg
54 LN-9252-06.4