Ransburg RMA Indirect A11600 - Manual (Page 42)

PROTECTIVE COVERS
It is recommended to use covers to reduce the
amount of overspray build-up on the shroud and
electrodes. Two covers are available, a white
lint free stretch cloth for covering the probes and
a foam cover (green) for the front shaping air
shroud. The white cloth cover should cover all of
the electrode except for the last 1-inch (25-4mm).
The green foam cover should be installed until
just past the radius edge of the shroud. Care is
to be taken when installing the white cloth covers
over the electrodes, do not bend them. (Devise a
fixture to help slide the cover over easier.)
When cleaning, do not get covers wet, it will attract
more overspray more quickly. Push them back,
clean surface, dry thoroughly, and slide back to
original position. Depending on conditions, covers
should be replaced after each shift (8 hours).
>
Make sure covers DO NOT trap mois-
ture. Moisture on covers can inhibit the
performance of the applicator. Large
amounts of trapped fluids can become
floating grounds. These conditions may
lead to unwanted sudden discharge of
energy in the form of a spark.
C A U T I O N
!
Covers:
A11565-00 White Stretch, Lint Free Covers
A11564-00 - Foam Elastic Covers (Green)
RMA-303 Indirect Charge - Operation
Ransburg
38 LN-9252-06.4