IAI America RCP2W-RA10C - Manual (Page 14)

8
Precautions in Handling
1. Do not set the speed or acceleration/deceleration settings beyond the
rated values.
Please do not set the speed or acceleration/deceleration settings beyond the rated values. It may cause
an occurrence of vibration, malfunction, or shorten the product life.
Setting especially the acceleration/deceleration beyond the rated values may cause a creep or a slip of
the coupling.
2. Back and forth operation in a short distance may cause wear of grease.
Continuous back and forth operation within a distance less than 30mm may cause wear of grease.
It is recommended to have 5 rounds of back and forth operation in a distance more than 50mm after every
5,000 to 10,000 rounds of the short distance operation. A layer of the grease will recover.
3. Turn the servo ON after putting the actuator or rod away from the
mechanical end.
Turning the servo ON near the mechanical end may disturb the magnetic pole phase detection,
and may cause the magnetic pole unconfirmed error or the excitation detection error.
Put the slider or rod away from the mechanical end when performing this operation.
4. Make sure to attach the actuator properly by following this operation
manual.
Using the product with the actuator not being certainly retained or affixed may cause abnormal noise,
vibration, malfunction or shorten the product life.