Belt replacement and adjustment, 1 belt inspection, 2 belts to be used – IAI America RCP2W-RA10C User Manual
Page 75
69
11. Belt Replacement and Adjustment
11. Belt Replacement and Adjustment
Applicable Unit : RCP2-RA8R
11.1 Belt Inspection
Remove the end plate and check the belt visually for the inspection process. The condition of the belt
deteriorates as the time passes and would cause such problems as abrasion. Regular replacements are
recommended in intervals of such occasions as when;
Ɣ WKHWHHWKRUWKHHGJHVRQWKHEHOWDUHFRQVLGHUDEO\ZRUQRXW
Ɣ WKHEHOWLVVZHOOHGGXHWRRLOEHLQJDSSOLHGRU
Ɣ WKHWHHWKRUWKHEDFNRIWKHEHOWLVWRUQ FUDFNHG
It is recommended to set the regular intervals to replace the core wire for the reinforcement of the toothed
belt because it is difficult to clarify if it is deteriorated or not by checking the appearance or looseness.
11.2 Belts to be used
The following belt is applied when the product is shipped out from our factory.
Ɣ 6055XEEHU676&OHDQ7\SH(Bando Chemical Industries, Ltd.)
*
The belt used to the product is as described above. However it may be replaced with an equivalent belt
in some cases.