IAI America RCP2W-RA10C User Manual
Page 74
68
10. Maintenance
[2]
Before applying grease, move the
rod by more than a half the stroke.
To apply grease to the ball screw,
spray grease into the screw hole.
(Keep the spraying time to within 1
second.)
Apply grease to the rod slide surface
using your fingers.
[3]
After the necessary parts have been
greased, move the rod back and
forth to let the grease spread evenly.
[4]
Apply silicone sealer to the threaded
part of the screw removed in [1], and
then install the screw back in the
original position.
Caution: Never use spray oil instead of grease, but always use spray grease. Also keep the spraying
time to within 1 second. Do not spray grease continuously for more than 1 second or repeat
spraying twice or more. If an excess amount of grease is applied, oil may flow into the
electronic components and cause malfunction.
In case the grease got into your eye, immediately go to see the doctor to get an appropriate
care.
After finishing the grease supply work, wash your hands carefully with water and soap to
rinse the grease off.