Teledyne LeCroy WavePro Automation Command - Manual (Page 388)

Automation Command and Query Reference Manual - Control Reference
FindLevel Action
When this action control is used, SDA2 will set the PercentLevel to 50% and will set the AbsLevel to
halfway between the base and top of the input signal.
Description
InputSUT Enum
This control specifies whether the input Signal Under Test is single ended (from one source, such as
C2) or differential (from a pair of sources, such as C2 and C3).
Description
Values
Diff Differential signal, a "plus" and "minus" side, from two sources; SDA2 will calculate the difference.
Single Single ended signal, in one source
LevelType Enum
This control sets whether PercentLevel or AbsLevel is used to define the threshold for detecting
transitions in the input signal.
Description
Values
Absolute
Percent
PercentLevel Double
From 0 to 100 step 1 Range
When LevelType is set to Percent, this control specifies the threshold level. Its value is percent from
base (0%) to top (100%).
Description
1-374
918501 RevA