Teledyne LeCroy WavePro Automation Command - Manual (Page 487)

Automation Command and Query Reference Manual - Control Reference
ConnectedToSuperKnob Bool
GoToEnd Action
When in multi-zoom mode, scroll to the end of the source waveform, who's last point will be centered
on the graticule.
Description
GoToStart Action
When in multi-zoom mode, scroll to the start of the source waveform, who's first point will be centered
on the graticule.
Description
HorZoomIn Action
Horizontally zoom in all the traces included in MultiZoom.
Description
HorZoomOut Action
Horizontally zoom out all the traces included in MultiZoom.
Description
MultiZoomOn Bool
Turn MultiZoom On and includes all the Zx automatically if any viewed.
Description
QuickZoom Action
Zoom all Cx that are on at an horizontal factor of 10.
Description
ResetAll Action
Reset all Zx to their default settings.
Description
ResetZoom Action
Resets the zoom settings to their default values.
Description
VariableHorZoom Bool
Enable/Disable the variable Horizontal Zoom control. If enabled, the HorZoom control may be set to a
value other than the standard 1, 2, 5 sequence.
Description
MultiZoomOn Bool
QuickZoom Action
ResetAll Action
ResetZoom Action
VariableHorZoom Bool
1-473
918501 RevA