Vanguard VCBA ver.10.xx User Manual
Page 33
VCBA VERSION 10.xx SOFTWARE MANUAL
REV 2
31
4.11.1. Toggling the Display of the Velocity Curve
To plot the velocity curve on the graphic test results:
1. From the File menu click on System Config and then click on System Setup… The
following window will be displayed:
If the “Plot Velocity Curve” checkbox is not already checked, click on the checkbox and a
check mark will appear. Click on the “Save” button, and then click on the “OK” button. If
you do not click on the “Save” button, any settings you change will only stay active for
the current session and will be reset the next time you run the software.
2. Click on the Graph/Results menu and the graphic test results will be displayed and will
include the velocity curve as shown below:
Velocity Curve