Vanguard VCBA ver.10.xx - Manual (Page 57)

VCBA VERSION 10.xx SOFTWARE MANUAL REV 2
55
NOTES
• Stroke Low is the minimum distance of contact travel.
• Stroke High is the maximum distance of contact travel.
• Velocity Low is the minimum contact Close velocity.
• Velocity High is the maximum contact Close velocity.
• Overtravel Low should always be zero.
• Overtravel High is the maximum contact travel distance above the
Close position.
• Bounce Back Low is the minimum contact travel distance under the
Close position and is usually set to zero.
• Bounce Back High is the maximum contact travel distance under the
Close position.
Input the corresponding values for each field and click on the “OK” button. The
following window will be displayed:
11. This dialog box is used to set the Open Analysis Points (velocity calculation points). Click
on each drop down list and select the desired option, and then input the relevant value
in the input box below the drop-down list. The options for each analysis point are shown
below: