Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 361)

Network OS NETCONF Operations Guide 329
53-1003231-02
Chapter
24
Configuring Spanning Tree Protocols
In this chapter
• Spanning tree configuration with NETCONF overview . . . . . . . . . . . . . . . . 329
• Configuring STP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 330
• Configuring RSTP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 332
• Configuring MSTP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335
• Configuring PVST and Rapid PVST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 337
• Spanning tree configuration and management . . . . . . . . . . . . . . . . . . . . . 338
• Retrieving spanning tree-related information . . . . . . . . . . . . . . . . . . . . . . . 355
• Configuring all xSTP on DCB interface ports . . . . . . . . . . . . . . . . . . . . . . . . 356
Spanning tree configuration with NETCONF overview
This chapter provides procedures for configuring STP, RSTP, MSTP, PVST, and Rapid PVST using the
NETCONF interface. Refer to the Network OS Administrator’s Guide for the following related
information:
• Overviews of STP, RSTP, MSTP, PVST, and Rapid PVST
• Configuration guidelines and restrictions
• A summary of spanning tree configuration default values
• How to perform spanning tree operations using the Network OS command line interface
• Spanning Tree Protocol and VCS mode
• Spanning Tree Protocol and DiST
Through the NETCONF interface, you can perform the following operations on STP, RSTP, MSTP,
PVST, and Rapid PVST:
• Use the <edit-config> RPC to configure spanning tree globally and on each interface.
• Use the <get-stp-brief-info> custom RPC to obtain operational information about the spanning
tree protocols.
• Use the <get-config> RPC to validate configuration settings.
• STP, RSTP, MSTP, PVST, and Rapid PVST parameters are defined in the brocade-xstp YANG
module. For details, refer to the Network OS YANG Reference Manual.