Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 543)

Network OS NETCONF Operations Guide 511
53-1003231-02
Configuring and activating an IP route policy
32
<area-id>0</area-id>
</area>
</ospf>
</hide-ospf-holder>
</router>
</config>
</edit-config>
</rpc>
<rpc-reply message-id="913" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
You can configure the router to explicitly permit or deny specific IP addresses. The router permits all
IP addresses by default. If you want permit to remain the default behavior, define individual filters
to deny specific IP addresses. If you want to change the default behavior to deny, define individual
filters to permit specific IP addresses. Once you define a filter, the default action for addresses that
do not match a filter is “deny”. To change the default action to “permit”, configure the last filter as
“permit any any”.