Retrieving an ntp server ip address, Removing an ntp server ip address – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 83

Advertising

Network OS NETCONF Operations Guide

53-1003231-02

Network Time Protocol

Retrieving an NTP server IP address

Use the <show-ntp> custom RPC located in the urn:brocade.com:mgmt:brocade-ntp namespace to
return the IP address of the currently active NTP server. If no server is configured or no server can
be reached, “LOCL” is returned instead (for local switch time). The request is for the local switch
unless a switch ID is specified in the <rbridge-id> element.

NOTE

Specifying “all” in the <rbridge-id> element returns only local information.

The response includes either an <ip> element containing the IPv4 or IPv6 address, or a Boolean
<LOCL> element, with its value set to “true”.

<show-ntp xmlns="urn:brocade.com:mgmt:brocade-ntp">

<rbridge-id>66</rbridge-id>

</show-ntp>

</rpc>

rpc-reply message-id="303" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<node-active-server xmlns="urn:brocade.com:mgmt:brocade-ntp">

<rbridge-id-out>66</rbridge-id-out>

</node-active-server>

</rpc-reply>

Removing an NTP server IP address

Use this operation to remove an NTP server IP address from a list of server IP addresses. At least
one IP address in the remaining list must be a reachable, configured NTP server or the remove
request fails.

To remove an NTP server IP address from the list of server IP addresses, perform the following
steps.

1. Issue the <edit-config> RPC to configure the <ntp>/<server> node in the

urn:brocade.com:mgmt:brocade-ntp namespace.

2. In the <server> tag, include the delete operation.

3. Under the <server> node element, specify an <ip> element and include the IPv4 or IPv6

address of the server you want to remove.

<?xml version="1.0" encoding="UTF-8"?>

<edit-config>

</target>

<server xmlns="urn:ietf:params:xml:ns:netconf:base:1.0"

operation="delete">

</server>

</ntp>

</config>

</edit-config>

Advertising