Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 389)

Network OS NETCONF Operations Guide 357
53-1003231-02
Configuring all xSTP on DCB interface ports
24
a. In the <name> element, specify the interface name in [rbridge-id/]slot/port format or
port-channel number.
b. In the <shutdown> element, include the delete operation in the element tag to enable the
port.
c. Include the <spanning-tree> node element, which resides in the
urn:brocade.com:mgmt:brocade-xstp namespace.
4. Under the <spanning-tree> node, include the empty <autoedge> leaf element to enable
automatic edge detection on the DCB interface.
<?xml version="1.0" encoding="UTF-8"?>
<rpc message-id="2027" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<running/>
</target>
<config>
<interface xmlns="urn:brocade.com:mgmt:brocade-interface">
<tengigabitethernet>
<name>22/0/1</name>
<shutdown xmlns="urn:ietf:params:xml:ns:netconf:base:1.0"
operation="delete"/>
<spanning-tree xmlns="urn:brocade.com:mgmt:brocade-xstp">
<autoedge/>
</spanning-tree>
</tengigabitethernet>
</interface>
</config>
</edit-config>
</rpc>
<rpc-reply message-id="2027" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
Configuring the path cost for all xSTP
Use this procedure to configure the path cost for spanning tree calculations. The lower the path
cost means there is a greater chance of the interface becoming the root port. The range is 1
through 200000000. The default path cost is 2000 for a 10 Gbps interface.
To configure the path cost for spanning tree calculations on the DCB interface, perform the
following steps.
1. Issue the <edit-config> RPC to configure the interface node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the <interface> node, include the <gigabitethernet>, <tengigabitethernet>,
<fortygigabitethernet>, <hundredgigabitethernet>, or <port-channel> node element.
3. Under the <gigabitethernet>, <tengigabitethernet>, <fortygigabitethernet>,
<hundredgigabitethernet>, or <port-channel> node element, include the following elements.
a. In the <name> element, specify the interface name in [rbridge-id/]slot/port format or
port-channel number.
b. In the <shutdown> element, include the delete operation in the element tag to enable the
port.