Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 426)

394 Network OS NETCONF Operations Guide
53-1003231-02
Configuring LLDP global options
27
<rpc message-id="1107" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<running/>
</target>
<config>
<protocol xmlns="urn:brocade.com:mgmt:brocade-interface">
<lldp xmlns="urn:brocade.com:mgmt:brocade-lldp">
<mode>tx</mode>
</lldp>
</protocol>
</config>
</edit-config>
</rpc>
<rpc-reply message-id="1107" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
To enable both transmit and receive modes, delete the <mode> element by including the delete
operation in its tag.
<?xml version="1.0" encoding="UTF-8"?>
<rpc message-id="1108" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<running/>
</target>
<config>
<protocol xmlns="urn:brocade.com:mgmt:brocade-interface">
<lldp xmlns="urn:brocade.com:mgmt:brocade-lldp">
<mode xmlns="urn:ietf:params:xml:ns:netconf:base:1.0"
operation="delete"/>
</lldp>
</protocol>
</config>
</edit-config>
</rpc>
<rpc-reply message-id="1108" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
Configuring the transmit frequency of LLDP frames
The default transmit frequency is 30 seconds. The valid range is 4 through 180 seconds.
To configure the transmit frequency of LLDP frames, perform the following steps.
1. Issue the <edit-config> RPC to configure the <protocol> node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the <protocol> node, include the <lldp> node element, which resides in the
urn:brocade.com:mgmt:brocade-lldp namespace.
3. Under the <lldp> node, include the <hello> leaf element, and set its value to the number of
seconds between the transmission of LLDP frames.
The following example sets the transmit frequency to 45 seconds.