Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 432)

400 Network OS NETCONF Operations Guide
53-1003231-02
Configuring LLDP global options
27
</target>
<config>
<protocol xmlns="urn:brocade.com:mgmt:brocade-interface">
<lldp xmlns="urn:brocade.com:mgmt:brocade-lldp">
<profile>
<profile-name>UK_LLDP_IT</profile-name>
<description>Standard profile by Jane</description>
<mode xmlns="urn:ietf:params:xml:ns:netconf:base:1.0"
operation="delete"/>
<hello>10</hello>
<multiplier>2</multiplier>
<advertise>
<optional-tlv>
<management-address/>
<port-description/>
<system-capabilities/>
<adv-tlv-system-description/>
<adv-tlv-system-name/>
<dot1-tlv/>
<dot3-tlv/>
<dcbx-tlv/>
<dcbx-fcoe-logical-link-tlv/>
<dcbx-fcoe-app-tlv/>
<dcbx-iscsi-app-tlv/>
</advertise>
</profile>
</lldp>
</protocol>
</config>
</edit-config>
</rpc>
<rpc-reply message-id="1114" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
Configuring the iSCSI profile
You can configure an iSCSI profile to be applied to individual interfaces. However, the priority bit
must be set explicitly for each interface.
To configure iSCSI profiles, you must first configure the CEE map, if one has not already been
created, configure the iSCSI profile, and then apply that profile to the interfaces.
To configure the CEE map, perform the following steps.
1. Issue an <edit-config> RPC to configure the <cee-map> node in the
urn:brocade.com:mgmt:brocade-cee-map namespace.
2. Under the <cee-map> node, include the <name> element and set it to “default”—the only
currently supported name.
3. Under the <cee-map> node, include the <priority-group-table> list element once for each
priority-group table entry.
4. Under each <priority-group-table> node, include the following leaf elements: