Specifying the port-channel path cost for all xstp – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 379

Advertising

Network OS NETCONF Operations Guide

347

53-1003231-02

Spanning tree configuration and management

5. Under the <error-disable-timeout> node, include the <interval> element and specify the time

in seconds it takes for an interface to timeout.

<?xml version="1.0" encoding="UTF-8"?>

<edit-config>

</target>

<spanning-tree xmlns="urn:brocade.com:mgmt:brocade-xstp">

<mstp>

<error-disable-timeout>

</error-disable-timeout>

</mstp>

</spanning-tree>

</protocol>

</config>

</edit-config>

</rpc>

<rpc-reply message-id="2014" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<ok/>

</rpc-reply>

Specifying the port-channel path cost for all xSTP

For STP, RSTP, MSTP, PVST, or Rapid PVST, use this procedure to specify the port-channel path cost.
The default port cost is standard. The path cost options are:

•

custom—Specifies that the path cost changes according to the port-channel’s bandwidth.

•

standard—Specifies that the path cost does not change according to the port-channel’s
bandwidth.

To specify the port-channel path cost, perform the following steps.

1. Issue the <edit-config> RPC to configure the <protocol> node in the

urn:brocade.com:mgmt:brocade-interface namespace.

2. Under the <protocol> node, include the <spanning-tree> node from the

urn:brocade.com:mgmt:brocade-xstp namespace.

3. Under the <spanning-tree> node, include the <stp>, <rstp>, <mstp>, <pvst>, or <rpvst> node

element.

4. Under the <stp>, <rstp>, <mstp>, <pvst>, or <rpvst> node, include the <port-channel> node

element

5. Under the <port-channel> node, include the <path-cost> leaf element and specify “custom” or

“standard” to specify the port channel path cost.

<?xml version="1.0" encoding="UTF-8"?>

<edit-config>

</target>

Advertising