Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1169
Brocade Network Advisor SAN + IP User Manual
1097
53-1003155-01
Configuring encryption storage targets
25
FIGURE 481
Select Hosts dialog box
The dialog box contains the following information:
•
Hosts in Fabric table: Lists the available hosts in the fabric.
•
Selected Hosts table: Lists the hosts that have been selected to access the target.
•
Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
•
Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
•
Port Name: The user-assigned port name, if one exists; otherwise, the symbolic port name
from the device.
•
Port ID: The 24-bit Port ID of the host port.
•
VI Port WWN: The world wide name of the virtual initiator port.
•
VI Node WWN: The world wide name of the virtual initiator node.
•
Host Name: The name of the hosts that are in the same fabric as the encryption engine.
•
Port WWN text box: Type a world wide name for a host port.
NOTE
You must enter the host node world wide name before clicking Add, to add the WWN to the
Selected Hosts table.
•
Node WWN
text box: Type a world wide name for a host node.
NOTE
You must also enter the host port world wide name before clicking Add to add the node
WWN to the Selected Hosts table.
•
Device Type: The device type indicated by the fabric’s name service. The value is either
Initiator or Initiator + Target.