Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1398)

1326 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Swapping blades
30
4. Select the blade with which you want to replace the first blade from the second Swap Blades
list.
5. Select the Enable ports after swap is complete check box to enable ports on the destination
blade after the swap is complete.
6. Click OK.
NOTE
This operation disrupts the traffic on all ports for the selected blades.
7. Click Yes on the confirmation message.
Once the swap blade operation is complete, a “success” or “failure” message displays.