Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1171)

Brocade Network Advisor SAN + IP User Manual 1099
53-1003155-01
Configuring encryption storage targets
25
FIGURE 483 Confirmation screen
The Confirmation screen contains the following information:
• Encryption Engine: The slot location of the encryption engine.
• Container Name: The logical encryption name used to map storage targets and hosts to
virtual targets and virtual initiators.
• Target Device Port: The world wide name of the target device port.
• Host Node WWN: The world wide name of the host node.
• Host Port WWN: The world wide name of the host port.
• Host Name: The name of the host.
12. Verify the information is correct, then click Next, which creates the configuration.
The Configuration Status screen displays, which shows the status of the new container
configuration. (Refer to
Figure 484 .) The target and host that are configured in the target
container are listed, as well as the virtual targets (VT) and virtual initiators (VI).
NOTE
If you can view the VI/VT Port WWNs and VI/VT Node WWNs, the container has been successfully
added to the switch.