Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 2091
Brocade Network Advisor SAN + IP User Manual
2019
53-1003155-01
MAPS actions
50
For a complete list of categories and the associated measures and actions, refer to
categories, measures, and actions”
on page 1991. Options include:
•
Port tab — Rules defined on this tab measure thresholds on ports or SFPs to determine if
an out of range violation is sent for the port.
•
Switch Status tab — Rules defined on this tab measure thresholds at the switch or chassis
level to determine the switch operational status.
•
Fabric tab — Rules defined on this tab measure thresholds at the switch level to detect out
of range fabric-wide changes.
•
FRU tab — Rules defined on this tab measure thresholds on fans, power supplies, SFPs,
blades, or WWN cards to detect out of range FRU changes.
•
Security tab — Rules defined on this tab measure thresholds at the switch level to detect
out of range security changes.
•
Resource tab — Rules defined on this tab measure thresholds on temperature sensors or
at the chassis level to detect out of range resource usage.
•
FCIP tab — Rules defined on this tab measure thresholds on FCIP circuits to detect out of
range state, utilization, or packet loss.
•
Traffic / Flows tab — Rules defined on this tab measure thresholds on ports in the
configured group to detect out of range link utilization or on flows to detect out of range
flow changes.
•
FPI tab — Rules defined on this tab measures thresholds on the performances of the fabric
Each tab contains the following fields and components:
•
Rules list — Lists the rules defined for the selected policy.
•
Groups/Rules — Displays the default groups (under the System Groups node) and
user-defined groups (under the Custom Groups node) for the selected switch. The
available groups in the Rules table depend on the measure you selected in the Add/Edit
Threshold area. For example, if you selected an SFP measure, only SFP groups become
available. You can only configure a user-defined group on the Port and FCIP tabs. For more
information, refer to
Rules display below the appropriate group node based on rule targets.
•
Monitor Condition — A combination of the measure, time base, and threshold expression
for the rule.
•
Time Base — The duration by which to monitor the measure.
•
Actions check boxes — Actions configured for the rule. Each action has a column and each
action selected for a rule has a check mark. Supported actions include:
•
Status Marginal (switch status)
•
Status Critical (switch status)
•
RAS Log Event
•
Port Decommission
•
Fence (Port Fencing)
•
SNMP Trap
•
•
SFP Marginal (Port SFP status)
4. Click OK on the View Policy dialog box.