Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 805)

Brocade Network Advisor SAN + IP User Manual 733
53-1003155-01
Performance management
17
“Displaying VLANs in the VLAN view” on page 1443
“Displaying VLANs by products” on page 1445
Performance management
NOTE
Wireless access points in adaptive mode do not display in the Management application.
Historical performance enables you to collect data from managed wireless devices. You can use
the provided data collectors or create your own data collectors.
Instructions for collecting historical performance data are detailed in “IP historical performance
monitoring” on page 1662.
Policy Monitors
Use this feature to provide best practice guidelines for network setup at the fabric, switch, port and
device level as well as software configurations at the product and the Management application
level.
Instructions for configuring policy monitors are detailed in Chapter 47, “Policy Monitor” and include
information about the following:
• “Adding a configuration policy manager” on page 1873
• “Editing a configuration policy manager” on page 1880
• “Configuration rules” on page 1881
• “Running a configuration policy manager” on page 1900
• “Viewing a configuration policy manager report” on page 1901
Fault management
Fault management enables you to monitor your network using the following methods:
• Monitor logs for specified conditions and notify you or run a script when the specified condition
is met.
• Create event-based policies, which contain an event trigger and action.
• Configure E-mail event notification.
Instructions for configuring fault management are detailed in Chapter 48, “Fault Management” .