GW Instek GDS-3000 Series Programming Manual - Manual (Page 90)

GDS-3000 Programming Manual
90
:TRIGger:ALTernate
Set
Query
Description Sets alternating between source triggers on or off.
Syntax :TRIGger:ALTernate {OFF | ON |?}
Parameter OFF Alternate off
ON Alternate on
Return parameter Returns the Alternate trigger status (ON, OFF).
Example :TRIGger:ALTernate ON
Turns on alternating between source triggers.
:TRIGger:LEVel
Set
Query
Description Sets or queries the trigger level.
Syntax :TRIGger:LEVel {<NRf> | ?}
Parameter <NRf> Trigger level value
Return parameter Returns the trigger level as <NR3>.
Example :TRIGger:LEVel 3.30E-3
Sets the trigger level to 330mV/mA.
Note: This command is equal to :TRIGger:HLEVel
:TRIGger:TIMEOut:WHEn
Set
Query
Description Sets or queries the timeout trigger triggering point.
Note: Only applicable for 500MHz models with the
Timeout trigger APP installed.
Syntax :TRIGger:TIMEOut:WHEn {HIGH | LOW | EITher | ?}
Related
commands :TRIGger:TIMEOut:TIMER
Parameter/
Return parameter HIGH Sets the triggering point as stays high.
LOW Sets the triggering point as stays low.