GW Instek PEL-3000 Series User Manual - Manual (Page 104)

PEL-3000 User Manual
102
Memo 12 characters A user-created note for the
currently selected sequence.
Mode CC, CR, CV, CP Operating mode for the
sequence. +CV mode is
supported.
Range ILVL Low I range, low V range
IMVL Middle I range, low V range
IHVL High I range, low V range
ILVH Low I range, high V range
IMVH Middle I range, high V range
IHVH High I range, high V range
Loop Infinite,
01 ~ 9999 Sets the amount of times to
loop the selected sequence.
Last Load OFF, ON Set the load condition after
the end of the sequence.
Last Value The setting value of the load
for when Last Load = ON.
Chain Off, S01~S10 Sets the next sequence in the
chain, when not set to off.
Data Edit
Overview Each step in a normal sequence contains the
following setting parameters:
Setting Setting Range Description
Step 0001 ~ 1000 Selects/displays the current
step in the sequence.
 The number of available
steps is dependent on the
number of steps added using
the Insert Point[F1] functions.
Value The current, voltage, power
or resistance setting for the
selected operating mode.
Load ON, OFF Turns the load on or off for
the selected step.