GW Instek PEL-3000 Series User Manual - Manual (Page 66)

PEL-3000 User Manual
64
Level
Time
Level 2
Level 1
Timer1 Timer2 Timer1
Dynamic Mode
Note
Dynamic mode is not available for CV mode.
Operation 1. Make sure the load is off.
2. Press Main .
3. Select Dynamic or Static mode with the
Function[F4] soft-key.
 A different switching mode can be set for CC,
CR and CP mode.
4. For dynamic mode, set the Timer1 and Timer2
parameters using the scroll wheel and number
pad.
 Timer1 sets the Level1 on-time.
 Timer2 sets the Level2 on-time.
 Take the slew rate settings into consideration
when setting the timers.
 The frequency of the dynamic switching is
output via the TRIG OUT BNC.
 To select whether A Value or B Value is the
―active‖ setting, press the
Shift + Preset
keys.
 The ―active‖ value will be shown in the
Operation Status Panel.