GW Instek PEL-3000 Series User Manual - Manual (Page 98)

PEL-3000 User Manual
96
8. Choose the P/F-Time (pass/fail time) in
seconds.
 The P/F-Time refers to the P/F delay time. This
delay time includes the 0.06 P/F start test time,
as shown in the timing diagram on page 94.
P/F-Time Off, 0.0 ~ 119.9 seconds
9. Set the Short-Time in seconds.
 Has the same action as pressing the short key.
See page 61 for details about shorting the load.
Short-Time Off, 0.1 seconds ~ On-Time
10. Repeat steps 3 to 9 for all the steps in the
program.
 A maximum of 16 steps per program can be
created.
 Steps that are not configured are set to ―Skip‖
by default.
11. Press Save[F3] to save the program and all the
steps in the program.
 The program will be saved to internal memory.
 See the Save/Recall chapter on details on how
to save to Setup memory.
Recall Default Pressing Recall Default[F4] will recall the default
settings for each program/step. See page 178
for details.