KROHNE BM 102 Handbook - Manual (Page 8)

8 BM 102
Avoid cable kinks and fraying
Do not coil the cable less than 400 mm or 16 “ in diameter. Cable kinks or fraying will cause
measurement errors.
Storage temperature
Store within the given storage temperature limits.
1.2 Installation restrictions
Hazardous-duty systems (Ex, FM,…)
• Refer to the BM 102 MICROFLEX KEMA 00 ATEX 1101X Supplementary Installation and
Operating Instructions for further information on installing gauges approved for use in
hazardous locations. This document is available from your local KROHNE Sales office or on the
“Download Centre” on KROHNE’s website http://www.krohne.com/.
• Check that the flange, gasket and probe materials are compatible with the product. Read the
information given on the converter nameplate, the flange markings and specifications in the
approval certificates.
1.3 Mounting on the tank
1.3.1 Installation instructions: general notes
The fitter should give some thought to tank fittings and tank shape.
• Nozzle position in relation to the tank walls and other objects inside the tanks
(Warning : this free area will depend on the probe type selected: refer to later on in this section)
• Type of tank roof, i.e. floating, concrete, integral, etc; and base, i.e. conical, etc.
Whenever working on an installation, remember to:
• Disconnect the power supply before starting work.
However,
• The gauge may be installed when the tank contains product.