Martel Electronics MasterCAL - Manual (Page 36)

MasterCAL
Users Manual
26
Using the Backlight
Press C to toggle the display backlight on and off.
When the backlight is on, the G symbol shows at the
top of the display. You can minimize battery usage
by setting the calibrator to turn the display backlight
off automatically. When the backlight is on and Auto
Backlight Off is activated, the
a symbol shows at
the top of the display. To automatically turn off the
backlight after a set time, proceed as follows:
1. Press s .
2. Press d to highlight Off following Auto Backlight
Off .
3. Press e or the Choices softkey.
4. Press u to highlight On , then press e .
5. To accept the timeout period shown on the
display, press
Done to exit, and do not go on to
step 6.
6. To change the timeout period, press d to
highlight the timeout period following Backlight
Timeout .
7. Press e or the Choices softkey.
8. Enter your choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Press the Done softkey.
10. Press the Done softkey or s to exit Setup
mode.
Personalizing the Calibrator
You can load your name or some other
alphanumeric identifier into the calibrator to be
displayed at power-up and in saved results. Proceed
as follows to load an identifier:
1. Press s .
2. Press Next Page twice.
3. Press d to move the cursor to the same line
as ID .