Martel Electronics MasterCAL - Manual (Page 49)

Calibrator
Using Measure Mode
39
TC
mA mA V
RTD
RTD
SOURCE
30V
MAX 30V
MAX
30V
MAX MEAS
CAT
V
300V
MAX
OK
V
RTD
MEAS SOURCE
mA mA
RTD
V
300V
MAX 30V MAX
TC
V
RTD
MEAS SOURCE
mA mA
RTD
V
300V
MAX 30V MAX
TC
WRONG
gj14f.eps
Figure 13. Using a Jumper Correctly
8. If necessary, you can change between
°
C or
°
F
temperature units in Setup mode as follows:
a. Press s .
b. Press the Next Page softkey twice.
c. Use the u and d keys to move the cursor
to the parameter you which to change, then
press
e or the Choices softkey to
choose a setting for that parameter.
d. Press u or d to move the cursor to the
desired setting.
e. Press e to go back to the s display.
f. Press the Done softkey or s to exit Setup
mode.
9. If necessary, you can change between ITS-90 or
IPTS-68 Temperature Scale in Setup mode. The
procedure is the same as steps a through f
above.