Troubleshooting after upgrading, Smi-s switches must be removed, And rediscovered after upgrading – HP Storage Essentials NAS Manager Software User Manual
Page 704
Troubleshooting
672
NOTE:
If you see an error message when you enter this command, a previous certificate
may not have been created. You can ignore the error message.
4.
To create a new certificate containing the DNS name of the management server, enter the
following at the command prompt:
perl generateAppIQKeyStore.pl
5.
If the program is unable to detect a DNS name, enter the following at the command prompt:
perl generateAppIQKeyStore.pl create mycomputername
where mycomputername is the DNS name of the computer
6.
To copy the new certificate to the management server, enter the following at the command
prompt:
perl generateAppIQKeyStore.pl copy
The new certificate is copied to the correct location.
Troubleshooting After Upgrading
This section provides information on troubleshooting after upgrading. It includes the following
topics:
”
SMI-S Switches Must Be Removed and Rediscovered After Upgrading
SMI-S Switches Must Be Removed
and Rediscovered After Upgrading
You must remove and rediscover Cisco, QLogic, or CNT switches supported through SMI-S after you
upgrade the management server. These additional steps vary according to whether you do
discovery from HP SIM or HP SE.
IMPORTANT:
Refer to the support matrix for information on which models and firmware revisions
are supported through SMI-S.
HP SIM
1.
To remove elements from the HP SIM database:
a. Click Systems in the left pane.
b. Select the elements you want to delete.
c. Click Delete.
2.
Rediscover the Cisco, QLogic, or CNT switches in HP SIM. See ”
3.
Perform Discovery Data Collection. See ”
Step 4 - Discovery Data Collection or Get Details
HP SE