Black areas look hazy – HP Latex 360 Printer User Manual
Page 121
2.
Use your RIP to add lateral color bars on the side of the plot that is close to the ink supplies. The color
bars are designed to exercise all the printhead nozzles, to prevent the problem from occurring.
NOTE:
Not all RIPs provide this option.
3.
Add lateral color bars to the image, manually, before printing. In this case, you can either use the
standard colors, or decide to include a particular color in which you have noticed the problem. The
recommended width of each color bar is 3 mm.
4.
At the front panel, press
, then Image-quality maintenance > Color variation and text-line
correction > On.
If text, lines, or light solid areas are rough or blurred, try the following suggestions:
●
The printheads may be misaligned.This is likely if you have not aligned the printheads for a long time, or
if there has been a substrate jam. Print the printhead alignment status plot (see
alignment status plot on page 108
), and align the printheads if necessary (see
).
●
The optimizer printhead may have blocked nozzles. You can check this by printing the optimizer check
plot (see
2. The optimizer check plot on page 106
).
●
Water evaporates slowly from the ink in the unused nozzles, so the first drops of ink are ejected with
lower velocity. This may happen, for example, in nozzles not used during a whole printed swath,
causing the text or lines to be rough or blurred. You are recommended to go through steps 1 to 4 as
described above.
●
If a light area is close to the edge while printing on a thin substrate, ensure that the substrate is loaded
with the substrate edge on a rib of the platen to avoid local blurring. Alternatively, try rotating the
image so that the affected area is not at the edge of the substrate.
Black areas look hazy
If black areas look hazy or not sufficiently black, try these suggestions.
●
Increase the number of passes.
●
Laminate the print.
●
Substrate presets are designed to achieve consistent and reliable print quality on a broad range of
substrates. However, you may want to consider investing in the color management process, using
external tools and/or experts, to get specific results. The best dark colors on gloss vinyls and other
substrates are normally obtained when using as much black and as little composite as possible when
creating the ICC profile.
ENWW
Most-common print-quality problems 115