Load a roll onto the spindle – HP Latex 360 Printer User Manual
Page 52
●
If the strip is completely white (has no ink on it), the tested substrate is non-porous and can be
used for printing as described in this guide.
●
If there some ink on the strip, the tested substrate is porous and should not be used with the 310
or 330 printers. It may be used with the 360 printer and the ink collector.
11.
.
Load a roll onto the spindle
TIP:
As an alternative to the description here, you can see an animation of this procedure in the front panel:
press
, then Substrate > Substrate load > Learn how to load spindle.
1.
Make sure that the printer wheels are locked (the brake lever is pressed down) to prevent the printer
from moving.
2.
Lift the spindle lock lever to disengage the spindle.
3.
Remove the spindle from the printer.
CAUTION:
Do not insert your fingers into the spindle supports.
The spindle has a stop at each end to keep the roll in position. Remove the blue stop at the left end to
mount a new roll (the stop at the other end of a 76 mm (3 in) diameter spindle can also be removed, if
you wish). The stop slides along the spindle to hold rolls of different widths.
46
Chapter 3 Handle the substrate and troubleshoot substrate issues
ENWW