HP Latex 360 Printer - Manual (Page 155)

3. Wipe the sensor with a cotton swab to remove wet ink.
4. Wipe the sensor with a cotton swab, slightly dampened with 95% ethanol, to remove dried ink.
NOTE: 95% ethanol is not provided in the User Maintenance Kit. Please follow the manufacturer's
safety precautions when handling ethanol.
If the sensor window is heavily coated with dried ink, you may need to apply some pressure while
wiping, helping the cotton to absorb the ink. Continue cleaning with fresh swabs until the cotton stays
clean and the sensor window looks clean. When reflecting ambient light, a clean sensor shows a blue-
colored reflection that should extend uniformly across its whole surface. You can see this reflection by
moving closer and slightly changing your angle of view.
5. Remove the closed 95% ethanol container and the cotton swabs from the vicinity of the printer.
6. Wait three or four minutes to let the ethanol evaporate, before turning on the printer and reloading the
substrate.
Clean the exterior of the printer
Use a damp sponge or a soft cloth and a mild household cleaner such as non-abrasive liquid soap to clean the
outside of the printer and all other parts of the printer that you regularly touch as part of normal operation.
There may be some dampness from condensation under the fans of the curing module, which should be
wiped with a dry cloth.
WARNING! To avoid an electric shock, make sure that the printer is turned off and unplugged before you
clean it. Do not let water get inside the printer.
CAUTION: Do not use abrasive cleaners on the printer.
Move or store the printer
If you need to move your printer or store it for an extended period of time, prepare it correctly to avoid
possible damage.
1. Do not remove the ink cartridges, printheads or maintenance cartridge.
2. Make sure that no substrate is loaded.
3. Make sure that the printhead carriage is located in the service station (at the right end of the printer).
4. Make sure that the Ready message appears on the front panel.
5. Turn off the power by using the Power button on the front panel.
6. Also switch off the power switch at the rear of the printer.
ENWW Clean the exterior of the printer 149