HP Latex 360 Printer - Manual (Page 25)

To set the bottom margin at the front panel, press , then Substrate > Substrate handling options >
Extra bottom margin.
NOTE: The extra top/bottom margin set in the front panel is applied in addition to the top/bottom margin
selected in the RIP.
NOTE: The side margins can be adjusted in the RIP.
Request the printer’s internal prints
The internal prints provide various kinds of information about your printer. Request these prints from the
front panel, without using a computer.
Before requesting any internal print, make sure that substrate is loaded and that the Ready message
appears on the front-panel display.
To print an internal print, press , then Setup > Internal prints, then select the type of internal print that
you want.
The following internal prints are available:
● Usage report: Shows estimates of the total number of prints, number of prints by substrate family,
number of prints by print-quality option, and total amount of ink used per color. The accuracy of these
estimates is not guaranteed.
● Service information: Provides information that service engineers require.
Check lifetime usage statistics
There are two ways of checking your printer's usage statistics.
NOTE: The accuracy of the usage statistics is not guaranteed.
● From the Embedded Web Server, go to the Main tab and select History > Usage. See The Embedded
Web Server on page 19 .
●
From the front panel, press , then Setup > Internal prints > User information prints > Print
usage report.
The Embedded Web Server
Introduction to the Embedded Web Server
The Embedded Web Server is a Web server running inside the printer. You can use it to obtain printer
information, manage settings and presets, align printheads, upload new firmware and troubleshoot
ENWW The Embedded Web Server 19