HP Latex 360 Printer - Manual (Page 20)

goes into sleep mode, go to the front panel and press , then Setup > Front panel options > Sleep mode
wait time. Enter in minutes the wait time that you want, then press OK.
Change the loudspeaker volume
To change the volume of the printer's loudspeaker, go to the front panel and press , then Setup > Front
panel options > Speaker volume, and select Off, Low, or High.
Turn audio alerts on or off
To turn the printer's audio alerts on or off, go to the front panel and press , then Setup > Front panel
options > Enable audio alert or Disable audio alert. By default, audio alerts are enabled.
Change the front panel display brightness
To change the brightness of the front-panel display, press , then Setup > Front panel options >
Display brightness, then select a value by moving the scroll bar. Press OK to save the value.
Change the units of measurement
To change the units of measurement that appear on the front panel, press , then Setup > Front panel
options > Unit selection, then English or Metric.
The units of measurement can also be changed in the Embedded Web Server. See Access the Embedded Web
Server on page 21 .
Restore factory settings
To restore the printer settings to their original values as set in the factory, go to the front panel and press
, then Setup > Resets > Restore factory settings. This option restores all of the printer settings except
the Gigabit Ethernet settings and substrate presets.
Check printer status
The front panel and the Embedded Web Server both display the status of the printer, the loaded substrate,
and the ink system.
Check the status of the ink cartridges
You can see the ink levels in your ink cartridges by pressing on the front panel's home screen.
14 Chapter 1 Introduction ENWW